33
System control mode selection
Function settings
SiriusXM radio display
Hold down [SEL] for more than 2 seconds to open SXM function setting
screen.
Turn [VOL] to open alarm time setting screen.
Turn [VOL] back to SXM function setting screen.
SiriusXM function setting mode
Note: See below “Function settings” for its
inside setting.
Alarm time setting mode
Note: Refer page 40 and follow its steps from
2 to 6 to set alarm time if needed.
Channel direct selection mode
A channel is directly selected with the channel
number entry.
1
Hold down [SEL] for more than 2
seconds to open SXM function setting
screen.
2
The radio automatically enters the
SXM direct channel selection mode af-
ter 2 seconds when entering the SXM
function setting screen.
Channel direct selection mode
3
Press [!!!!!] or [!!!!!] to select a number.
4
Press [BAND] to enter the next digit.
5
If necessary, repeat steps 3 and 4 to
enter more digits of the channel num-
ber.
6
Push [SEL] when done entering the
channel number digits and the radio
tunes to the desired channel.
Notes:
”CHAN
+++!
UNAVAIL” is displayed when the re-
quested channel is not valid. Visit www.siriusxm.
com to see the list of channels available.
”CHAN
+++!
UNSUB” is displayed when the
requested channel is not part of the current
subscription package. Visit www.siriusxm.com for
information on subscription packages.
Signal strength indicator
[DISP] (Display)
switches the information on the display.
[!!!!!!] [ !!!!!]
selects a number.
[VOL]
opens the function setting.
(PUSH SEL :Select)
opens or exits the function setting.
determines the selection.
[BAND]
shifts to the next digit.
selects the code entry mode.
exits code entry mode.
changes a channel to be locked
or unlocked.
the next digit.