5
EnglishSafety precautions
Do not insert your fi ngers 
or other objects into the air 
conditioner indoor or outdoor 
unit, rotating parts may cause 
injury.
Do not touch the outdoor unit during 
lightning, it may cause electric 
shock.
Do not expose yourself directly to 
cold air for a long period to avoid 
excess cooling.
Do not sit or step on the unit, 
you may fall down accidentally.
Remote control
Do not allow infants and small 
children to play with the remote 
control to prevent them from 
accidentally swallowing the batteries.
Power supply
Do not use a modifi ed 
cord, joint cord, 
extension cord or 
unspecifi ed cord to 
prevent overheating 
and fi re.
 
To prevent overheating, fi re or 
electric shock:
• 
Do not share the same power outlet 
with other equipment.
• 
Do not operate with wet hands.
• 
Do not over bend the power supply 
cord.
• 
Do not operate or stop the unit by 
inserting or pulling out the power 
plug.
If the supply cord is damaged, 
it must be replaced by the 
manufacturer, service agent or 
similarly qualifi ed persons in order to 
avoid a hazard.
It is strongly recommended to be 
installed with Earth Leakage Circuit 
Breaker (ELCB) or Residual Current 
Device (RCD) to prevent electric 
shock or fi re.
To prevent overheating, fi re or 
electric shock:
• 
Insert the power plug properly.
• 
Dust on the power plug should be 
periodically wiped with a dry cloth.
Stop using the product if any 
abnormality/failure occurs and 
disconnect the power plug or turn off 
the power switch and breaker.
(Risk of smoke/fi re/electric shock)
Examples of abnormality/failure
• 
The ELCB trips frequently.
• 
Burning smell is observed.
• 
Abnormal noise or vibration of the 
unit is observed.
• 
Water leaks from the indoor unit.
• 
Power cord or plug becomes 
abnormally hot.
• 
Fan speed cannot be controlled.
• 
The unit stops running immediately 
even if it is switched on for 
operation.
• 
The fan does not stop even if the 
operation is stopped.
Contact your local dealer 
immediately for maintenance/repair.
This equipment must be earthed to 
prevent electrical shock or fi re.
Prevent electric shock by switching 
off the power supply and unplug:
 -Before cleaning or servicing,
 -When extended non-use, or
 -During abnormally strong 
lightning activity.