96
Figure 3 Figure 4
16.1.1.3 To Remove Discharge Grille
Figure 5
8.
Pull out the main
electronic controller
halfway.
6.
Detach the CN-DISP
connector then remove
the indicator PCB complete.
9.
Detach connector as labeled from the
electronic controller, then pull out the
main controller gently.
7.
Detach the Earth wire
screw.
5.
Remove the screw to dismantle
the terminal board complete.
CN-FM
CN-STM1
CN-TH
CN-DISP
RY-PWR
AC304 AC303
G301
Discharge Grille
11. Pull the Discharge Grille
downward gently to dismantle it.
10. Pull out to remove the drain hose
from the Discharge Grille.
To Next Page
Loading...
