95
16. Disassembly and Assembly Instructions
WARNING
High Voltage is generated in the electrical parts area by the capacitor. Ensure that the capacitor has discharged sufficiently before proceeding
with repair work. Failure to heed this caution may result in electric shocks.
16.1 CS-BE25TKE CS-BE35TKE
16.1.1 Indoor Electronic Controllers, Cross Flow Fan and Indoor Fan Motor Removal
Procedures
16.1.1.1 To Remove Front Grille
Figure 1
16.1.1.2 To Remove Electronic Controller
Figure 2
2. Remove 2 caps and 2 screws at the
bottom of discharge vane.
3. Hold both sides of the front grille and
remove it by pulling up and toward
you gently.
1. Lift to open the horizontal vane
gently.
4. Remove the Control Board
cover by releasing the hook.
To Next Page
Loading...
