69
4 REMOTE CONTROL RECEIVING SOUND OFF/ON MODE
The Remote Control Receiving Sound OFF/ON Mode will be activated if the Auto OFF/ON button is pressed
continuously for more than 16 seconds (4 “beep” sounds will occur at 16th seconds to identify the Remote
Control Receiving Sound Off/On Mode is in standby condition) and press “AC Reset” button at remote
control.
Press “Auto OFF/ON button” to toggle remote control receiving sound.
o Short “beep”: Turn OFF remote control receiving sound.
o Long “beep”: Turn ON remote control receiving sound.
After Auto OFF/ON Button is pressed, the 20 seconds counter for Remote Control Receiving Sound OFF/ON
Mode is restarted.
15.2 Remote Control Button
15.2.1 SET BUTTON
To check remote control transmission code and store the transmission code to EEPROM
o Press “SET” button continuously for 10 seconds by using pointer.
o Press “TIMER SET” button until a “beep” sound is heard as confirmation of transmission code changed.
15.2.2 RESET (RC)
To clear and restore the remote control setting to factory default.
o Press once to clear the memory
15.2.3 RESET (AC)
To restore the unit’s setting to factory default
o Press once to restore the unit’s setting.
15.2.4 TIMER ▲
To change indoor unit indicator’s LED intensity
o Press continuously for 5 seconds.
15.2.5 TIMER ▼
To change remote control display from Degree Celsius (°C) to Degree Fahrenheit (°F)
o Press continuously for 10 seconds.
To Next Page
Loading...
