a. Remote Control Reset
When the batteries are inserted for the first time, or the
batteries are replaced, all the indications will blink and the
remote control might not work.
If this happens, remove the back cover of the remote
control and you will find a resetting terminal, and by shorting
it with a minus screwdriver, it will return to normal.
b. Changing the wireless remote control transmission
code
When two indoor units are installed in the same room, in
order to prevent operating errors caused by using two
remote controls, set up the remote control [B
←→
A] switch.
The unit is set to A when it is shipped.
11.3. Remote Control
By adding a jumper wire to the remote control side, it is possible to select 4 transmission codes including one at time of
delivery condition (1).
Remote Control Indoor unit
Note
Switch SW B
←→
A J-B Segment Display
1 A —— A At product delivery
2 B —— B
3 A Jumper wire C
4 B Jumper wire D
Procedure:-
•
Press the Auto button (at indoor unit) continuously for 11 seconds or < 16 seconds; “beep”“beep”“beep” will be heard
and the current transmission code is displayed (A or b or c or d). To switch to condition (2) transmission code as above,
switch over the Remote Control A
←→
B switch to B; and press any button at the remote control to set the transmission
code.
•
To switch to condition (3) and (4) transmission code, follow the same procedure as mentioned above.
87
CS-G95KE CU-G95KE / CS-G125KE CU-G125KE
To Next Page
Loading...
