d. Outdoor Electronic Controller Removal Procedure
1. Remove the top pane and front panel
Fig. 20
2. Remove the Outdoor Electronic Controller
Fig. 22
Caution! When handling electronic
controller, be careful of electrostatic
discharge.
•
Be save to return the wiring to its original position
•
There are many high voltage components within the heat
sink cover so never touch the interior during operation.
Wait at least two minutes after power has been turned off.
Fig. 21
Fig. 23
Note: Use magnetic type of screw driver to avoid dropping of the
screws.
92
S-G95KE CU-G95KE / CS-G125KE CU-G125KE
To Next Page
Loading...
