67
WARNING
15. Disassembly and Assembly Instructions
High Voltage is generated in the electrical parts area by the capacitor. Ensure that the capacitor has discharged sufficiently before proceeding with
repair work. Failure to heed this caution may result in electric shocks.
15.1 Indoor Electronic Controllers, Cross Flow Fan and Indoor Fan Motor
Removal Procedures
15.1.1 To remove front grille
Figure 1
15.1.2 To remove power electronic controller
Figure 2
2. Remove 2 caps and 2 screws at the
bottom of discharge vane.
1. Lift to open the vertical vane
gently.
3. Hold both sides of the front grille and
remove it by pulling up and toward
yourself gently.
4. Remove the control
board cover by
releasing the hook.
To Next Page
Loading...
