Remote Control
Transmitter
Note: The illustrations in this manual are for explanation purposes only and may differ from the
actual unit. It is subjected to change without notice for future improvement.
PRODUCT OVERVIEW
Troubleshooting
● Operation delayed for few minutes after restart.
➤ This is a normal self protection control.
● Sound like water fl owing during operation.
➤ Caused by refrigerant fl ow inside.
● Mist emerges from indoor unit.
➤ Condensation effect due to cooling process.
● Noisy during operations.
➤ Installation work could be slanted or front panel didn’t close properly.
● Remote control/display does not work.
➤ Check whether batteries are correctly inserted or need replacement.
● The unit cannot operate.
➤ Check either circuit breaker is tripped, power plug is inserted correctly or
timer is used correctly.
● Outdoor unit emits water/steam.
➤ Condensation or evaporation happens at piping surface.
O
P
E
N
• Make sure it is not obstructed.
• Maximum distances: 10m.
• Certain fluorescent lights may
interfere with signal transmission.
Consult your dealer.
Remote Control Preparation
■ About
Remote Control Signal
5. Press again to confi rm
• Timer operation will be based on
current time set.
• The batteries can be used for
approximately 1 year.
• The batteries must be
recycled or disposed of
properly.
1. Pull out
2. Insert batteries
(AAA or R03)
3. Press CLOCK button
4. Set
current
time
• To operate the unit if the
remote control is misplaced or
malfunctioning.
Action
Operation
mode
Press once
Automatic
Operation
Press until “beep”
sound
Cooling
Operation
• To OFF, press again the Auto OFF/
ON button.
• To switch the remote control signal
receiving sound off or on.
1. Press until “beep” sound and
release.
2. Press again until “beep-beep”
sound and release.
3. Press to switch the sound off or
on.
(Long “beep” - OFF; short “beep”
- ON)
Auto OFF/ON Button
27
CS-PW18DKE CU-PW18DKE
To Next Page
Loading...
