46
4 REMOTE CONTROL RECEIVING SOUND OFF/ON MODE
The Remote Control Receiving Sound OFF/ON Mode will be activated if the Auto OFF/ON button is pressed
continuously for more than 16 seconds (4 “beep” sounds will occur at 16th seconds to identify the Remote
Control Receiving Sound Off/On Mode is in standby condition) and press “AC Reset” button at remote control.
Press “Auto OFF/ON button” to toggle remote control receiving sound.
- Short “beep”: Turn OFF remote control receiving sound.
- Long “beep”: Turn ON remote control receiving sound.
After Auto OFF/ON button is pressed, the 20 seconds counter for Remote Control Receiving Sound OFF/ON
Mode is restarted.
14.2 Remote Control Button
14.2.1 SET BUTTON
To check remote control transmission code and store the transmission code to EEPROM.
o Press “SET” button for more than 10 seconds by using pointer.
o Press “TIMER SET” button unit a “beep” sound is heard as confirmation of transmission code change.
14.2.2 RESET (RC)
To clear and restore the remote control setting to factory default
o Press once to clear the memory.
14.2.3 RESET (AC)
To restore the unit’s setting to factory default
o Press once to restore the unit’s setting.
14.2.4 TIMER ▲
To change indoor unit indicator’s LED intensity
o Press continuously for 5 seconds.
14.2.5 TIMER ▼
To change remote control display from Degree Celsius to Degree Fahrenheit.
o Press continuously for 10 seconds.
To Next Page
Loading...
