Panasonic CS-RE9NKE - Indoor Fan Motor Operation; Outdoor Fan Motor Operation

34
2nd & following judgment (every 15 minutes after 1st judgment)
JUDGE CONDITION REFERANCE MODE
If indoor intake temp – Remote control temp
setting ≥ +3
 Cool mode if previously is Cool /
Heat mode
 Dry mode if previously is Dry mode
If -2 ≤ indoor intake temp. –
Remote control
Temp. setting < +3
Maintain current mode
If indoor intake temp. – Remote control
temp. setting < -2
Heat mode
12.2 Indoor Fan Motor Operation
Basic Rotation Speed
i. Manual Fan speed
Fan motor’s number of rotation is determined according to remote control setting.
Remote control
O O O O O QUIET
Model
Tab Hi Me+ Me Me- Lo QLo
COOLING(rpm)
1150 1030 920 810 700 600
CS-RE9NKE
HEATING(rpm)
1040 890 830 770 710 650
COOLING(rpm)
1150 1060 970 880 790 620
CS-RE12NKE
HEATING(rpm)
1150 1010 950 890 830 680
COOLING(rpm)
1320 1160 1040 920 800 730
CS-RE15NKE
HEATING(rpm)
1300 1140 1060 980 900 740
ii. Auto Fan Speed (Cooling, Soft Dry Mode)
According to room temperature and setting temperature, indoor fan speed is determined automatically.
The indoor fan will operate according to pattern below.
Fan speed
Higher
Medium
Lower
A b c d e f g h a b
B. Feedback control
• Immediately after the fan motor started, feedback control is performed once every second.
• During fan motor on, if fan motor feedback 2550 rpm or < 50 rpm continue for 10 seconds, then fan motor error
counter increases, fan motor then stops and restarts. If the fan motor counter becomes 7 times, then H19 - fan motor
error is detected. Operation stops and cannot on back.
12.3 Outdoor Fan Motor Operation
Outdoor fan motor is operated with one fan speed only. It starts when compressor starts operation and it stops 30
seconds after compressor stops operation.
Intake temp.- setting temp.
DRY
COOL
HEAT
-6 -5 -4 -3 -2 -1 0 1 2 3 4 5 6
MAINTAIN
CURRENT MODE
COOL
/DRY
HEAT
Intake temp.- setting temp.
-6 -5 -4 -3 -2 -1 0 1 2 3 4 5 6