ET
Select ON or OFF timer
Set the 
time
Confi rm
•  Example of application at living room:
Morning: ON   at 07:00 (Wake up)
OFF   at 08:00 (Out for work)
Evening: ON   at 17:00 (Back home)
OFF   at 22:00 (Sleep)
•  To cancel ON or OFF timer, press 
N
 or
OFF
 to select respective   or   then press 
SET
.
•  Upcoming timer will be displayed and will be activated
in sequence.
•  When ON Timer is set, the unit may start earlier (up 
to 15 minutes) before the actual set time in order to 
achieve the desired temperature on time.
•  Timer operation is based on the clock set in the 
remote control and repeats daily once set. For clock 
setting, please refer to Remote Control Preparation at 
back cover.
8
TO ENJOY CLEAN & FRESH AIR
PATROL/
PATROL
NORMAL
PATROL - To monitor air quality
•  Detects air quality; e-ion operation 
activates when air quality is at dirty 
level.
•  Regardless of air quality, to 
maintain air freshness e-ion 
activates automatically (PATROL 
SENSOR indicator turns red) when: 
-  2 minutes after the unit is on, or  
-  exceeds 4 hours at clean level.
Indicator Air Quality
Blue Clean
Orange Moderate
Red Dirty
•  Can be activated even when the unit is turned off. 
•  Patrol starts automatically with the unit switched on with 
OFF/ON
.
 - To freshen and purify the air
•  Generates negative ions to produce fresh air effect and 
attract dust which will then be captured at the positively 
charged e-ion fi lters.
•  Can be activated even when the unit is turned off. In this 
condition, fan speed and air swing can not be adjusted.
9
TO IMPROVE HUMIDITY AND MOISTURE LEVEL
•  This operation reduces air dryness and provides you with 
a comfortable living environment during COOL mode only.
•  When vertical airfl ow direction is set to AUTO, it stops at 
lower position to avoid cold air contact. However, you can 
adjust the louver direction manually.
10
TO ENJOY QUIET OPERATION
•  This operation reduces airfl ow noise.
11
TO REACH TEMPERATURE
QUICKLY
•  This operation will stop automatically after 4 hours.
12
Press and hold for 5 seconds to dim or restore the 
unit’s indicator brightness.
13
Press and hold for approximately 10 seconds to 
show temperature setting in °C or °F.
14
Press to restore the remote control’s default setting.
15
Not used in normal operations.
S18KKQ, S24KKQ, S28KKQ
6