English
17
See "To learn more..." for details.
How to use
To set the timer
2 sets of ON and OFF timers are available
to turn ON or OFF the unit at different preset
times.
ON
OFF
SET
CANCEL
123
TIMER
AN
E
1 2 3
1
Select ON or OFF
timer
Example:
OFF at 22:00
• Each time pressed:
OFF
Cancel
2
Set the time
2
3
Confi rm
SET
TIMER
• To cancel ON or OFF timer, press
ON
or
OFF
to select respective or then press
CANCEL
.
• If timer is cancelled manually or due to power
failure, you can restore the timer again by
pressing
ON
or
OFF
to select respective or
then press
SET
.
• The nearest timer setting will be displayed and
will activate in sequence.
• When ON Timer is set, the unit may start
earlier (up to 15 minutes) before the actual
set time in order to achieve the desired
temperature on time.
• Timer operation is based on the clock set in
the remote control and repeats daily once set.
For clock setting, please refer to Quick guide.
Auto Restart Control
• If power is resumed after a power failure, the
operation will restart automatically after a period
of time with previous operation mode and airfl ow
direction.
• This control is not applicable when TIMER is set.
ECONAVI
To optimise energy saving
NANOE-G
To purify the air
NANOE-G
• nanoe-G starts automatically when the unit is
turned on with
OFF/ON
.
• Can be activated even when the unit is turned
off. In this condition, the unit will operate as a fan
with AUTO fan speed and fl ap swing.
To deactivate viruses/bacteria on the fi lter
NANOE-G
POWER
• After the unit is turned off, the nanoe-G in-fi lter
deactivation may activate up to 150 minutes.
Turning on the unit cancels this operation.
• To disable this operation in the future, press and
hold
NANOE-G
until a short beep sound is heard. This
will not disable the nanoe-G to purify the air.
• To restore the nanoe-G in-fi lter deactivation,
press and hold
NANOE-G
until a long beep sound is
heard.
AIR SWING
To adjust airfl ow direction
(Remote control display)
• Keeps the room ventilated.
• In COOL/DRY mode, if AUTO is set, the fl aps
swings left/right and up/down automatically.
• In i AUTO-X mode, if AUTO is set, the horizontal
fl ap is fi xed at the lower position and shift to the
upper position after reaches set temperature.
The vertical fl ap movement depends on human
activity sensor. If manual is set, the horizontal
and vertical fl ap are fi xed at the predetermined
position.
• Do not adjust the fl ap by hand.
Note
ECONAVI
,
QUIET
,
AUTO
COMFORT
,
NANOE-G
• Can be activated in COOL and DRY mode
and can be cancelled by pressing the
respective button again.
i AUTO-X
,
ECONAVI
,
QUIET
,
AUTO
COMFORT
• Cannot be selected at the same time.
F569797_YA0115-0.indb 17F569797_YA0115-0.indb 17 21/1/2015 10:24:13 AM21/1/2015 10:24:13 AM
To Next Page
Loading...
