12
Cleaning instructions
To ensure optimal performance of the unit,
cleaning has to be carried out at regular
intervals. Dirty unit may cause malfunction and
you may see nanoe-G indicator blinks or error
code “H99”. Please consult authorised dealer.
• Switch off the power supply and unplug before
cleaning.
• Do not touch the aluminium fi n, sharp parts may
cause injury.
• Do not use benzine, thinner or scouring powder.
• Use only soap ( pH 7) or neutral household
detergent.
• Do not use water hotter than 40 °C / 104 °F.
Indoor unit
nanoe-G Generator
Once every 2 weeks
• Clean with dry cotton bud.
• Do not touch during operation.
Air fi lters
Once every 2 weeks
• Wash/rinse the fi lters gently
with water to avoid damage
to the fi lter surface.
• Dry the fi lters thoroughly under shade, away
from fi re or direct sunlight.
• Replace any damaged fi lters.
Remove air fi lter Attach air fi lter
Insert into the unit
i AUTO-X
Aluminium fi n
Front panel
Air fi lters nanoe-G Generator
Human activity
sensor
Indoor unit
Wipe the unit gently with a
soft, dry cloth.
Coils and fans should be clean
for at least every 6 months by an
authorised dealer.
Human activity sensor
Do not hit or violently press or poke it with a sharp
object. This can lead to damage and malfunction.
Outdoor unit
Clear debris that surround the unit.
Clear any blockage from drain pipe.
Front panel
Wash gently and dry.
Remove the front panel
1
Release the
hooks at
both ends
2
Pull out and lift up
i AUTO-X
Close it securely
i AUTO-X
1
Insert
at both
sides
2
Push in
3
Close down
4
Press both ends and center of the front panel
ACXF55-11420_SM0717-0.indd 12ACXF55-11420_SM0717-0.indd 12 16/6/2017 2:54:35 PM16/6/2017 2:54:35 PM
To Next Page
Loading...
