15
English
Troubleshooting
The following symptoms do not indicate malfunction.
Symptom Cause
POWER indicator blinks during HEAT mode
with no warm air supply (and fl ap is closed).
• The unit is in defrost mode (and AIR SWING has been
set to AUTO).
Operation is delayed a few minutes after
restarting.
• The delay is a protection to the unit’s compressor.
Cooling/heating capacity is reduced during
lowest fan speed setting.
• The lowest fan speed is to have a low noise operation,
so cooling/heating capacity may be reduced depending
on the condition. Increase the fan speed to increase the
capacity.
In COOL mode, when the room temperature
reaches near the set temperature, the
compressor stops, then the indoor unit fan
speed reduced.
• To prevent the room humidty rising. The indoor fan will
resume running according to the set fan speed when
room temperature increase.
Indoor fan stops occasionally during heating
operation.
• To avoid unintended cooling effect.
Indoor fan stops occasionally during automatic
fan speed setting.
• This is to help remove the surrounding odour.
Airfl ow continues even after operation has
stopped.
• To extract the remaining heat from the indoor unit
(maximum 30 seconds).
The room has a peculiar odour. • This may be due to damp smell emitted by the wall,
carpet, furniture or clothing.
Cracking sound during operation. • Changes in temperature caused the unit to expand and
contract.
Water fl owing sound during operation. • Refrigerant fl ow inside the unit.
Mist emerges from indoor unit. • During cooling operation, the discharged cold air may
condense to water vapour.
Outdoor unit emits water or steam. • During cooling operation, condensation occurs on
cold pipes and the condensed water may drip from the
outdoor unit.
• During heating operation, frost formed on the outdoor
unit during deice cycle melts and is discharged as
water or steam.
Discoloration of some plastic parts. • Discoloration is subjected to the types of materials
used in plastic parts. It is accelerated when exposed to
heat, sun light, UV light or environmental factors.
Wireless LAN indicator is ON when the unit
is OFF.
• The unit’s wireless LAN connection with the router has
been activated.
Cleaning the Air Conditioner / Troubleshooting
ACXF55-32681.indb 15ACXF55-32681.indb 15 1/20/2022 6:14:43 PM1/20/2022 6:14:43 PM
To Next Page
Loading...
Need help?
General
