Panasonic CT-32SX12F - Instructional Flow Chart for Service Mode

-22-
Instructional flow chart for service mode
Adj.
needed?
NORMAL MODE
Press Action + Volume up simultaneously (on receiver)
Adj.
needed?
WHITE
SCREEN
(ON REMOTE)
RECALL
WHITE
SCREEN
RED
SCREEN
GRN.
SCREEN
BLUE
SCREEN
POWER
(ON REMOTE)
SERVICE MODE
• “CHK” turns red.
• VOLUME up/down operate normally.
• Customer controls are set to nominal level.
ENTRY TO SERVICE MODE
• Select CABLE mode.
•SetSLEEP time for 30 Min.
• Tune to Channel 124.
• Adjust VOLUME to minimum.
•PressVOL DOWN on receiver.
EXIT
EXIT
Figure 23.Flow chart for service mode.
N
Y
N
Y
(ON REMOTE)
RECALL
(ON REMOTE)
A
(ON REMOTE)
ACTION
To view the adjustments
menu press POWER on
remote.
Once in adjustments menu press
VOL right/left and CH up/down on
remote to select adjustment.
Press ACTION on remote to enter the
adjustment.
AGING MODE
• Press VOL UP and ACTION simultaneously on TV
• Yellow “CHK” appears in upper left corner of screen.
• VOLUME up/down operate rapidly.
• Customer controls are set to nominal level.
IMPORTANT NOTE:
Always verify that TV is out
from service mode.
To exit service mode, just unplug TV from AC line
or turn it OFF; or press ACTION and POWER on
the receiver simultaneously for at least 2 seconds.
To exit service mode, just unplug TV from AC line
oturnitOFF;orpressACTION and POWER on
the receiver simultaneously for at least 2
seconds.
ACTION
ACTION