56
11 Installation Instruction
11.1. Auto switch operation
The following operations can be performed by pressing the
“AUTO” switch.
1. AUTO OPERATION MODE
The Auto operation will be activated immediately once the
Auto Switch is pressed.
2. TEST RUN OPERATION (FOR PUMP DOWN/
SERVICING PURPOSE)
The Test Run operation will be activated if the Auto
Switch is pressed continuously for more than 5 sec. to
below 8 sec. A “pep” sound will occur at the fifth sec., in
order to identify the starting of Test Run operation.
11.2. Changing the remote control transmission code
1. Press AUTO SW continously for 11 seconds (Buzzer
sound = pep pep pep).
2. After 11 seconds release AUTO SW, then press Remo-
Con TIMER “ ” SW continuously for 5 seconds. Reset
code will be transmitted. After transmitted reset code,
release TIMER “ ” SW.
3. Press Remo-Con “OFF/ON” switch. The new Remo-Con
No. will be accepted and memorized, after which the new
Remo-Con No. can be used.
Remo-Con No. change in Remote Controller
1. Remove battery from the battery compartment in the
Remote controller.
2. At left side of battery compartment, ther is a small
opening at the centre in which a jumper (J_A) can be
seen. Also in Remo-Con PCB shown below Jumper (J_B)
can be seen.
To Next Page
Loading...