the Front Grille. (Fig. 1).
- Remove the 3 caps and 3 screws at the bottom of the Front
Grille. (Fig. 1)
- Remove the Front Grille by releasing the 3 hooks at the top of
the Front Grille. (Fig. 1)
- Unhook the tabs at the Control Board to remove the Control
Board Cover. (Fig. 2)
2. To remove the Main Electronic Controller:
- Release the 2 Particular Piece. (Fig. 3)
- Release the CN-REC/DISP connectors. (Fig. 4)
- Release the CN-TH connector. (Fig. 4)
- Release the CN-MAIN connector. (Fig. 4)
- Release the CN-STM1 connector. (Fig. 4)
- Release the CN-STM2 connector. (Fig. 4)
- Release the hooks that hold the Electronic Controller. (Fig. 3)
3. To remove the Power Electronic Controller:
- Release the CN-001 connector. (Fig. 4)
- Release the CN-002 connector. (Fig. 4)
Fig. 1
Fig. 2
Fig. 3
To Next Page
Loading...
