Panasonic CY-VMC7000U - Page 16

19
CY-VMC7000U
10
E
N
G
L
I
S
H
When you connect a car navigation system through
RGB cord [Panasonic Car Navigation (not available
yet)]:
Car Navigation ON : Press [NAVI] (NAVIGATION).
Car Navigation OFF : Press [NAVI] (NAVIGATION) again.
When you connect a car navigation system to VTR1-
IN or VTR2-IN terminal (other brand’s car navigation
system):
Car Navigation ON : Press [NAVI] (NAVIGATION).
Car Navigation OFF : Press [NAVI] (NAVIGATION) again.
Or press [MODE] to change to the VTR1 or VTR2 mode.
Select the same mode (VTR1 or VTR2) as the terminal that con-
nected to a car navigation system (VTR1-IN or VTR2-IN).
DVD video/audio
output
RGB: car navigation
RGB input cord
VTR1-IN
VTR2-IN
Panasonic Car
Navigation System
CY-VMC7000U
Control Unit
CY-VMC7000U
Display Unit
(Example)
Other brand’s car
navigation system
CY-VMC7000U
Control Unit
VTR1-IN
VTR2-IN
(Example)
Press [MODE] to change to the VTR1 or VTR2 mode.
Select the same mode (VTR1 or VTR2) as the terminal that is
connected to a DVD video player (VTR1-IN or VTR2-IN).
Note: This unit is not equipped with a power amplifier. If you
connect a DVD player / receiver equipped with a power amplifi-
er (such as CQ-DVR909U) to this unit, you can enjoy powerful
sound.
CY-VMC7000U
Control Unit
VTR1-IN
VTR2-IN
Panasonic DVD
Player/Receiver
(CQ-DVR909U)
VTR-OUT
FRONT
(Example)
Note: When you connect a Panasonic car navigation system with a
built-in DVD player, use an RCA cord as well.