!6 Power Connector
Insert the Mounting Collar w into the
dashboard, and bend the mounting
tabs out with a screwdriver.
1
e Mounting
Spring
!1 Flat-Head Screw
t Mounting Bolt
3
Insert Trim Plate q.
4
After installation
reconnect the negative
(–) battery terminal.
5
Attach the Mounting Springs e
to the display unit.
2
!9 Display Unit/Control Unit
Connecting Cord
Secure the rear of the unit.
Fix the rear of the unit to the car body by either
method (a) or (b) shown at right after fixing
Power Connector !6 and Display Unit/Control
Unit Connecting Cord !9.
❏ Installation Procedures
(When using Mounting Collar w)
w Mounting Collar
Dashboard
Tab
Fastening the Mounting Collar
The tabs to be bent vary depending on the car.
Bend them with a screwdriver to fasten the
Mounting Collar w securely in the dashboard.
To Next Page
Loading...
