37
CY-VMC7000U
28
E
N
G
L
I
S
H
¡We strongly recommend that you wear gloves for installation work to protect yourself from injuries.
¡When bending the mounting tab of the mounting collar with a screwdriver, be careful not to injure your
hands and fingers.
Caution : Do not disconnect the battery terminals of a car with trip or navigational computer since all user
settings stored in memory will be lost. Instead take extra care with installing the unit to prevent shorts.
Caution : Please follow the laws and regulations of your state, province or country for installation of the
unit.
¡Disconnect the cable from the negative (–) battery
terminal (see caution below).
¡Unit should be installed in a horizontal position
with the front end up at a convenient angle, but
not more than 30°.
less than 30°
❏ Transportation bracket removal
Be sure to remove the transportation brackets before use (installation).
Use Binding-Head Screws (M5 x 6 mm) for installation.
Be careful not to lose these Binding-Head Screws.
Display Unit
Binding-Head
Screws
(M5 x 6 mm)
Binding-Head
Screws
(M5 x 6 mm)
Transportation
Bracket
Transportation
Bracket
Mounting the Display Unit
❏ Precautions
This unit should be professionally installed. In case of difficulty, please consult with your nearest professional installer.
1. This unit only operates in a 12-volt DC negative ground system.
2. Follow the electrical connections carefully (a page 42 to 47). Failure to do so may result in damage to the unit.
3. Connect the power lead after all other connections are made.
4. Be sure to connect the battery lead (yellow) to the positive terminal (+) of the battery or fuse block (BAT) terminal.
5. Insulate all exposed wires to prevent short circuiting.
6. Secure all loose wires after installing the unit.
7. Please carefully read the operating and installation instructions of the respective equipment before connecting it to this
unit.
To Next Page
Loading...
