126
Perform remote operation of the unit over a network
Setting
9
Touch [Register].
z The settings are registered and the “Select part” dialogue
closes.
z To cancel registration, touch [Cancel].
9
10
Touch [Register].
z The settings are registered and the “Edit user sttngs”
dialogue closes.
10
11
Register other users.
z Repeat steps 3 to 10.
Continued on next page
6
Select the privileges.
z Select “0:Administr.”, “1:Operator”, or “2:GenralUser”.
z Only one person can have the “0:Administr.” setting.
6
7
Select what is to be operated.
z The “Select part” dialogues are displayed when you touch
this.
z Select what is to be operated (“I/D unit”, “Control Gr.”,
“Area”).
z When the privileges are set to “0:Administr.”, all operations
are available so it is not possible to select what to operate.
7
8
Select the devices to be operated (8-1)
and touch
(8-2).
z The devices to be operated move to the list on the right
(Web Supported Unit). Select the devices to be operated
and touch
to restore.
z Multiple devices can be selected to be operated.
8-
1
8-
2
Setting the users
127
Perform remote operation of the unit over a network
Setting
The “Web user settings” screen
A: Users with a check mark next to them will be the
subject of the changes to the user settings.
B: The users with the check marks next to them
will be allowed to perform operations over the
network.
Priv. This shows the privileges of the
user.
0:Administr.
1:Operator
2:GenralUser
I/D unit Users can use the categories with
a “”.
Control Gr.
Area
C: The “Edit user sttngs” dialogue is displayed
when you touch this.
A B
C
12
Put a check mark in the “Register”
column.
z Select the users that can operate over the network.
12
13
Touch [Register].
z The setting is registered.
z To cancel the settings, touch [Cancel].
13
Setting the users
To Next Page
Loading...
