Panasonic CZ-CAPRA1

21
(EN)
Model No. CZ-CAPRA1
Dimensions (H × W × D) 120 x 70 x 32.5 (mm)
Weight 130 g
Temperature/
Humidity range
0 ˚C to 40 ˚C /
20 % to 80 % (no condensation)
*Indoor use only.
Power Source
DC12 V
(supplied with room air conditioner)
Specications
Supplied accessories
*Wirings other than the RAC connection wiring are not included (eld supplied item).
*When outputting the operation status or alarm status, a 12 V DC external power source
for relays is required (eld supplied item).
z Safety Precautions .....................2
z About This Adaptor ..................20
z Specications ...........................21
z Supplied accessories ...............21
z Dimensions ...............................21
z Installation Precautions ...........21
z Basic Wiring Diagram ..............22
z Mounting and Wiring ................ 23
z Connecting External Equipment .....25
z Setup .........................................26
CONTENTS
Dimensions
RAC connection
wiring (1)
5P White
4P Red
Length: 1.9 m
Screw (4)
M3.8 x 16
Installation
Instructions (1)
Clamper (3)
70
120
32.5
(mm)
108
35
Installation Precautions
 Installation Location
z Avoid the following locations for installation.
• Location where the controller will be splashed with water or affected by dampness
or humidity • Under direct sunlight • Location near heat source • Uneven surface
• Location that is subject to excessive vibration or physical impacts. (Fixing screws
may come off, and the controller may drop.)
z Install the controller away from any sources of electrical noise.
z Install the controller at a location with suitable temperature and humidity for
using.
ENGLISH