Panasonic CZ-RTC6BL

12
Maintenance func
 RC. setting mode  Auto address  Detailed settings  Sensor info.  Service check
 Set elec. consumption
Check this item as necessary.
Steps 1 and 2 are common operations for each item.
1
Press and hold the
3 buttons simultaneously,
for at least 4 seconds.
Press , , .
2
Select the
item to set.
Press → .
Number for the
selected item
Total number of items
RC. setting mode
3
Set.
(Select the Code no. and Set data.)
Press
→ . (Repeat)
Code no.
Set data
4
Press .
 After Selecting [YES], the unit restarts.
Code no . Set data
01 Main/sub Set this when using 2 remote controllers.
• 0000: Sub
• 0001: Main (factory setting)
2F Password change Set the administrator password.
• 0000 to 9999
• 0000 (factory setting)
Auto address
3
Set.
( Select the Code no. [A1] and O/D unit no.)
Press → . (Repeat)
4
Press .
 After Selecting [YES], the unit restarts.
Code no. O/D unit no.
A1
Set the Auto address for each O/D unit no.
Select the O/D unit no. (outdoor unit) for Auto address.
• Outdoor unit number
 Set Auto address after all units are turned on and 90 seconds or more have passed.
 Operate the units after Auto address is set and 90 seconds or more have passed.
Attention
Code no.
O/D unit no.