Panasonic Diga DMR-E80H - Marking Places to Play Again-MARKER

22
RQT6984
Playing back
Other methods of play
You can mark positions by pressing [MARKER]. Also use on-screen
menus to mark, recall, and clear positions.
[HDD] [RAM] [DVD-R]
Mark up to 999 positions. The unit records the markers directly onto
the disc and they remain intact even if you remove the disc.
[DVD-A] [DVD-V] [VCD] [CD] [MP3]
Mark up to 5 positions. The markers clear when you open the disc
tray.
During play
Press [MARKER].
One marker is added.
1 During play
Press [DISPLAY].
The on-screen menus appear.
2 Press [3, 4] to select “Play” and
press [1].
e.g., DVD-RAM
3 Press [3, 4] to select “Marker” and
press [1] to highlight the first aster-
isk (¢).
[HDD] [RAM] [DVD-R] [DVD-A] [DVD-V] [VCD] [CD] [MP3]
4 Press [2, 1] to select an asterisk (¢)
and press [ENTER].
One marker is added.
To recall a marker
Press [2, 1] to select a marker number and press [ENTER].
≥Play starts from the marked position.
To clear markers
Press [2, 1] to select a marker number and press [CANCEL].
≥An asterisk replaces the number and the position is cleared.
To clear the on-screen menus
Press [RETURN].
Marking places to play again—MARKER
Marking positions directly
Using on-screen menus to mark positions
DVD TV
INPUT SELECT VCR Plus+ OPEN/CLOSE TV/VIDEO
CH
VOLUME
SKIP
DIRECT NAVIGATOR PLAY LIST
TOP MENU
ENTER
MENU
FUNCTIONS RETURN
STOP PAU S E PLAY/x1.3
SLOW/SEARCH
CANCEL
123
DVD TV
4
5
6
789
0
100
FRAME CM SKIP TIME SLIP
ERASE
REC PROG/CHECK ADD/DLT
DUBBING REC MODE STATUS MARKER
AUDIO SETUP DISPLAY
POSITION
MEMORY
POWER
3, 4, 2, 1
ENTER
RETURN
HDD DVD
DISPLAY
MARKER
CANCEL
Disc
Video
Audio
OFF
1s10
††††††††††
Marker
Play
Repeat play
1s10
††††††††††
†††††
When marking positions 11 and above
[HDD] [RAM] [DVD-R]
1 Press [2, 1] to highlight “1–10”.
2 Press [3, 4] to select “11–20”.
You can select the next group of 10 when the current group is
full.
3 Press [1].
The first asterisk is highlighted.
4 Press [ENTER] to mark a position.
[Note]
≥You cannot use this feature if:
– the disc’s elapsed play time is not shown in the display.
– you are using a play list. [HDD] [RAM]
– protection (cartridge ➜page 10, disc ➜page 36) is set (you
can still recall the markers to play a position). [RAM]
≥Subtitles around markers may fail to appear.
≥Markers are cleared when you finalize DVD-R (➜page 36).
≥Markers on HDD, DVD-RAM and DVD-R are ordered by time,
so marker numbers can change when you add and delete
them.
1
2
1s10