39
RQT8023
Editing
After performing steps 1–5 (➡ 38)
§
Multiple editing is possible.
After performing steps 1–7 (➡ 38)
§
Multiple editing is possible.
Title operations
Erase Title
§
[HDD] [RAM] [-R] [-RW‹V›] [+R]
(➡ below, “For quicker
editing”)
Press [2, 1] to select “Erase” and press [ENTER].
≥Once erased, the recorded contents are lost and cannot be restored. Make certain before proceeding.
≥The available recording space on DVD-R or +R does not increase when you erase titles.
≥Available recording space on DVD-RW (DVD-Video format) increases only when the last recorded title is
erased. It does not increase if other titles are erased.
Properties
[HDD] [RAM] [-R] [-RW‹V›] [+R]
[-RW‹VR›]
Information (e.g., time and date) is shown.
≥Press [ENTER] to exit the screen.
Title Name
[HDD] [RAM] [-R] [-RW‹V›] [+R]
You can give names to recorded titles.
➡ 53, Entering text
Setup Protection
§
Cancel Protection
§
[HDD] [RAM]
If set, this will protect the title from accidental erasure.
Press [2, 1] to select “Yes” and press [ENTER].
The lock symbol appears when the title is protected.
Shorten Title
[HDD] [RAM]
(➡ below, “For quicker
editing”)
You can remove unnecessary part of the recording such as commercials.
1 Press [ENTER] at the start point and end point of the
section you want to erase.
2 Press [3, 4] to select “Exit” and press [ENTER].
≥Select “Next” and press [ENTER] to erase other sections.
3 Press [2, 1] to select “Erase” and press [ENTER].
Change Thumbnail
[HDD] [RAM] [-R] [-RW‹V›] [+R]
(➡ below, “For quicker
editing”)
You can change the image to be shown as the thumbnail picture in the Title View.
1 Press [1] (PLAY) to start play.
2 Press [ENTER] when the image you want to use as a
thumbnail is shown.
To change the thumbnail
Restart play and press [3, 4] to select “Change”, then press [ENTER] at
the point you want to change.
3 Press [3, 4] to select “Exit” and press [ENTER].
Divide Title
[HDD] [RAM]
(➡ below, “For quicker
editing”)
You can divide a title into two.
1 Press [ENTER] at the point you want to divide the title.
2 Press [3, 4] to select “Exit” and press [ENTER].
3 Press [2, 1] to select “Divide” and press [ENTER].
To confirm the division point
Press [3, 4] to select “Preview” and press [ENTER]. (The unit plays 10
seconds before and after the division point.)
To change the division point
Restart play and press [3, 4] to select “Divide”, then press [ENTER] at the point where you want to divide
the title.
[Note]
≥The divided titles retain the name and CPRM property (➡ 68) of the original title.
≥Video and audio just before and after the dividing point may momentarily cut out.
Properties
No.
Ch.
Date
001
4
6/20/2002
Start
Rec. Time
10:00 AM
2:15 (SP)Wed
Dinosaur
ENTER
10 10/27 Mon
007 008
8 10/27 Mo
--- ---
DIRECT NAVIGATOR Title View
HDD
Start
Next
Exit
0:43.21
Play
008
End
- -:- -.- - - -:- -.- -
Start End
DIRECT NAVIGATOR Shorten Title
HDD
Picture
Video
ENTER
Change
Exit
0:00.01
0:01.05
Change
008
DIRECT NAVIGATOR
Change Thumbnail
HDD
Start play and select
the thumbnail position
Picture
Video
ENTER
Preview
Exit
Divide
0:43.21
-- : -- . --
Divide
008
Play
DIRECT NAVIGATOR Divide Title
HDD
Picture
Video
ENTER
Chapter operations
Erase Chapter
§
[HDD] [RAM]
Press [2, 1] to select “Erase” and press [ENTER].
≥Once erased, the recorded contents are lost and cannot be restored. Make certain before proceeding.
Create Chapter
[HDD] [RAM]
(➡ below, “For quicker
editing”)
Select the point where you want to start a new chapter while viewing the
title.
1 Press [ENTER] at the point you want to divide.
≥Repeat this step to divide at other points.
2 Press [3, 4] to select “Exit” and press [ENTER].
Combine
Chapters [HDD] [RAM]
Press [2, 1] to select “Combine” and press [ENTER].
≥The selected chapter and following chapter are combined.
Create
Exit
0:43.21
Play
008
DIRECT NAVIGATOR Create Chapter
HDD
Picture
Video
ENTER
For quicker editing
≥Use search, slow-motion (➡ 31) or Time Slip (➡ 32) to find the desired point.
≥Press [:, 9] to skip to the end of a title.
EH50English.book Page 39 Tuesday, February 1, 2005 6:36 PM
To Next Page
Loading...
Need help?
General
