33
RQT9135
Operation during Recording
Check the recording
programme
Press [STATUS ].
Display the recording
programme on the TV
screen
It is necessary to display the recording programme onto the TV screen to perform operations such as
pause.
≥If the input was switched: Press [INPUT SELECT].
≥If the channel was switched: Press [WXCH].
≥If the drive was switched: Press [DRIVE SELECT].
To stop recording
It is necessary to display the programme you want to stop on the TV screen while 2 programmes
simultaneous recording. (➡ above)
Press [∫].
≥From the start to the end of the recording is called one title.
To pause recording
It is necessary to display the programme you want to pause on the TV screen. (➡ above)
Press [;].
≥Press again to restart recording.
You can also press [¥ REC] to restart.
(Title is not split into separate titles.)
≥When the recording in DR mode is paused, that part will show up as still picture instantaneously while
playback.
Switch the input
Press [INPUT SELECT].
Switch to other channel
Press [WXCH].
Perform 2 programmes
simultaneous recording
Record other programme with steps 1–5 on page 23.
≥One of the 2 programmes needs to be digital broadcasting recorded with DR mode.
≥Channel switch / input switch while performing 2 programme simultaneous recording will switch between
the 2 recording programmes.
Recording programme
displayed on the TV screen
e.g., while 2 programmes simultaneous recording
090 NINE HD
HDD
REC1
002 ABC TV REC2
Recording programme not
displayed on the TV screen
“REC1” and “REC2” will light
REC1
REC2
Advanced recording
DMRXW300GN-RQT9135-L_eng.book 33 ページ ２００８年４月３０日 水曜日 午後６時１１分
To Next Page
Loading...
Need help?
General
