53
RQT9135
Recording broadcasts from external equipment
[HDD]
e.g., Connecting to the AV3 terminals on the front
≥Turn off the unit and external equipment before connecting.
§
The S VIDEO terminal achieves a more vivid picture than the
VIDEO terminal.
Preparation
≥Press [DRIVE SELECT] to select the HDD drive.
≥When the output signal from the external equipment is NTSC,
change the “TV System” to “NTSC” in the Setup menu (➡ 84).
1 While stopped
Press [INPUT SELECT] to select the
input channel for the equipment you
have connected.
e.g., If you have connected to AV3 input terminals, select
“AV3”.
2 Press [REC MODE] to select the
recording mode.
≥DR, FR mode cannot be selected.
3 Select the channel on the other
equipment.
4 Press [¥ REC].
Recording starts.
To skip unwanted parts
Press [;] to pause recording. (Press again to restart recording.)
To stop recording
Press [∫].
See also “Important notes for recording” (➡ 28).
L/MONO - AUDIO- R
VIDEO
S VIDEO
AV3 IN
Audio/Video
cable
S Video
cable
§
Ye ll o w W h i t e R e d
This unit
External equipment
Connect to Audio/Video output terminals.
Copying titles/Recording broadcasts from external equipment
DMRXW300GN-RQT9135-L_eng.book 53 ページ ２００８年４月３０日 水曜日 午後６時１１分
To Next Page
Loading...
