88
RQT9135
Changing the unit’s settings
∫ Setting the proxy server
In most cases, default settings can normally be used without making
any changes.
Please use this setting when instructed to by your Internet provider.
≥Set the proxy server only after the connection test is completed
properly.
1 Press [FUNCTION MENU].
2 Press [3, 4] to select “To Others” and press
[OK].
3 Press [3, 4] to select “Setup” and press [OK].
4 Press [3, 4] to select “Network Settings” and
press [OK].
5 Press [3, 4] to select “Proxy Server Settings”
and press [OK].
6 Press [3, 4] to select “Proxy Address” and
press [OK].
(➡ 71, Entering text)
After the input of “Proxy Address” is completed
7 Press [3, 4] to select “Proxy Port Number” and
press [OK].
8 Enter numbers with the numbered buttons and
press [OK].
9 Press [2, 1] to select “Yes” and press [OK].
To set back to default setting
After performing steps 1–5 (➡ above)
1 Press [3, 4] to select “Initialize” and press [OK].
2 Press [2, 1] to select “Yes” and press [OK].
RETURN
Proxy Server Settings
Initialize
Proxy Address
Proxy Port Number
OK
0
1
Proxy Port Number
Please input HTTP Proxy Server Port Number
and press “OK”. The number will be set to “0”
by pressing “OK” when there is no number
input.
0 - Number9
DMRXW300GN-RQT9135-L_eng.book 88 ページ ２００８年４月３０日 水曜日 午後６時１１分
To Next Page
Loading...
