236
Wi-Fi/NFC
1 Select the menu.
2 Select [Via Network] or [Direct], and connect. (P259)
3 Select a device you want to connect.
•
When the connection is complete, the screen is displayed. To change the send setting,
press [DISP.]. (P266)
4 Take pictures.
•
The pictures are sent automatically after taking them.
• To change the setting or disconnect, press [Wi-Fi]. (P224)
You cannot change the settings while sending pictures. Wait until sending is complete.
Sending an image each time a recording is made ([Send Images While
Recording])
[Wi-Fi] > [New Connection]>[Send Images While
Recording]>[Smartphone]
On your smartphone/tablet
When connecting with [Via Network]:
1 Turn on the Wi-Fi function.
2 Select the wireless access point you want to connect to, and set.
3 Start “Image App”.
¢
(P227)
When connecting with [Wi-Fi Direct] or [WPS Connection] in [Direct]:
1 Start “Image App”.
¢
(P227)
When connecting with [Manual Connection] in [Direct]:
1 Turn on the Wi-Fi function.
2 Select the SSID that matches the one displayed on the screen of this unit, and
then enter the password.
3 Start “Image App”.
¢
(P227)
¢ A window indicating that the smartphone/tablet is connecting to the camera is
displayed. If you are using an Android device, press the back key. If you are using an
iOS device, close the window.
To Next Page
Loading...
