VQT3C15
10
Adjusting the LCD screen
angle
A Open the screen.
B Standard
C Free
D Compact
About the LCD screen
There may be 0.01 % or less chance of missing or constantly
turned on pixels, but this is not a malfunction.
Preparing the Power
Supply
The unit is in the standby condition (the [Í] indicator lights)
when the AC power supply cord is connected. The primary
circuit is always “live” as long as the AC adaptor is connected
to an electrical outlet.
To conserve power
This unit consumes 0.3 W ([For[U.S.A.]) or 0.4 W ([For[Canada])
(Approximately 4 W ([For[U.S.A.]) or 4.5 W ([For[Canada]) when
Quick Start is set to “On”) of power even when turned off. When
the unit is not going to be used for a long time, disconnect the
AC power supply cord from the household AC outlet.
This unit can be used in places without an AC outlet, such as
outdoors, by attaching the supplied battery pack.
≥ The battery is not charged at the time of purchase. Charge
before initial use.
≥ The battery is designed only for use with this unit. It cannot
be used with other equipment.
∫ Attaching the battery pack
Turn the unit off before attaching or detaching the battery pack.
1 Bring in from the left, aligning the grooves.
2 Slide all the way to the right until you hear a "click".
Check to make sure it is securely fastened.
Using the unit connected to the
AC adaptor
Using the battery pack
AC adaptor
(supplied)
To a household
AC outlet
AC power supply cord
(supplied)
1
2
3
RELEASE
DETACH ATTACH
RELEASE
DETACH ATTACH
Bottom side of this unit
Battery pack
(supplied)
DMP-B200P&PC-VQT3C15_eng.book 10 ページ ２０１０年１２月２２日 水曜日 午後６時２分
To Next Page
Loading...
Need help?
General
