Panasonic DMP-B500 - Loading the Disc, SD Card or USB Device

13
VQT2J83
Getting started
Loading the disc, SD card
or USB device
1 Open the screen and press [OPEN].
2 Set the disc holding the unit with your hand
and close the lid.
≥ Set the disc securely until you hear a "click", with the
label side up. (Double-sided disc: place the label side up
that you want to play back)
3 Close the screen.
≥ Some discs may start playing when they are loaded with the
unit turned on.
≥ About discs with a cartridge
jDVD-RAM, DVD-R: Remove the disc from the cartridge
and set the disc in the tray. Cartridge discs cannot be used.
jPlace the disc back into the cartridge for storage to prevent
dirt and scratches after use.
≥ Do not touch the lens as it may
make it dirty.
Insert the SD card into the SD card slot.
With the cut corner at the bottom, insert the card straight in the
direction shown in the figure, until you hear a sound.
B SD card access indicator
≥ SD card access indicator will flash while the card is being
read. Do not remove the SD card from this unit while the
indicator is flashing.
To remove the card
Press the centre of the card until it “clicks”, and pull the card out
straight.
≥ Insert the media making sure it is oriented correctly.
≥ Setup screen may display on the connected Panasonic
device. Setup according to the operating instructions of the
connected device. (Depending on the device, you may need
to setup to a mode that connects to a PC)
≥ Refer to the operating instructions of the connected devices
regarding the connection/setup.
Disc
SD card

Lens (A)

USB device
Panasonic digital camera, etc.
Connect to USB terminal
USB connection cable (not supplied)
Specified cable such as
accessory of the USB equipment
DMPB500EB-VQT2J83_eng.book 13 ページ ２０１０年３月３０日 火曜日 午後３時４２分