Panasonic DMP-BDT300 - Page 39

39
VQT2T11
Reference
The settings of the audio output vary depending on the connected equipment. Refer to the table below and set each of the items.
Press [SETUP] > “Sound” > Set each item
For details of the each item, refer to page 31.
Recommended audio output setting
Example of connected equipment
TV via HDMI
*1
Receiver with
HD
audio
*2
decoder via
HDMI
Receiver without
HD
audio
*2
decoder via
HDMI
Receiver via
COAXIAL or
OPTICAL
Receiver
via analogue
output
*3
Setup menu
“Digital
Audio
Output”
“Dolby D/Dolby
D +/Dolby
TrueHD”
“PCM” “Bitstream
” “PCM” “PCM” No effect
“DTS/DTS-HD” “PCM” “Bitstream” “PCM” “PCM” No effect
“BD-Video
Secondary
Audio”
“Off” “Off” “Off” “Off” “Off”
“PCM Down Conversion” No effect No effect No effect
“Off
”
*4
No effect
“Downmix” “Stereo” No effect No effect
“Stereo
”
*5
No effect
“High Clarity Sound” “Enable”
“Disable
”
*6
“Disable”
*6
“Disable”
*6
“Disable”
*6
≥ Because underlined items are the factory presets, it is not necessary to change these settings.
*1
If connected to TV via the COAXIAL, OPTICAL or AUDIO OUT terminal, these settings have no effect.
*2
HD audio: Dolby Digital Plus, Dolby TrueHD, DTS-HD High Resolution Audio and DTS-HD Master Audio
*3
Set “Analog Audio Output” to “7.1ch” or “2ch (Downmix) + 5.1ch”. (Press [SETUP] > TV / Device Connection)
*4
If the connected equipment that does not support 96 kHz, set to “On”.
*5
If the connected equipment that supports the virtual surround function, set to “Surround encoded”.
*6
When connected to TV via the HDMI terminal for outputting image, set to “Enable”.
DMP-BDT300EG-VQT2T11 _eng.book 39 ページ ２０１０年３月３日 水曜日 午後６時３３分