Troubleshooting
SQT0826
90
Troubleshooting guide
Cannot play back.
• The disc is dirty. (> 12)
• The disc is scratched or marked.
• The disc may not be able to play back if it was
not finalised or a Top Menu was not created on
the equipment used for recording.
Audio and video momentarily pause.
• DVD-R DL and +R DL discs have two writable
layers on one side. Video and audio may
momentarily cut out when the unit is switching
layers.
BD-Video or DVD-Video is not played.
• Ensure the disc is for the correct BD-Video
region code or DVD-Video region number, and
is not defective.
You have forgotten your rating PIN.
• The rating level returns to the factory preset.
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• “00 RET” is displayed on the front panel
display.
2 Repeatedly press [1] (right) until “03 VL” is
displayed on the front panel display.
3 Press [OK].
• “INIT” is displayed on the front panel
display.
Image for the Quick View is not smooth.
• Image may not be played back smoothly in case
of high definition titles.
Cannot edit.
• You may not be able to edit on the HDD if there
is no available space. Delete any unwanted
titles to create empty space. (> 43)
Cannot create a video playlist.
• Creation or editing of playlists cannot be done
on this unit.
Play
Cannot play the disc on other players.
• Refer to “Play on other players”. (> 11)
Edit
The available recording time does not
increase even after deleting titles on the disc.
• [BD-R] [DVD-R] [+R] Available space on the disc
does not increase even after deleting titles.
• [DVD-R W] [+RW] Available space on the disc
increases when you delete the last title.
DMR-BWT450GL_eng.book 90 ページ ２０１５年２月５日 木曜日 午後３時２８分
To Next Page
Loading...
