• The TV Guide On Screen system was designed such that all TV viewing would
be done using your DVD Recorder to select the channels. When a cable box is
used, and the DVD Recorder is placed in the standby mode, the DVD Recorder
will cause the cable box to automatically scan channels to search for program
data. In this situation, if the cable box were also connected directly to the TV, it
would be impossible to view one channel continuously.
• Program data in the TV Guide On Screen system may be incomplete due to the
following:
1. The unit is unplugged and loss of power occurs.
2. If a cable box is used and the cable box was turned off or if a cable signal
outage occurred.
A loss of program data due to one of the above conditions would not indicate a
technical problem with your unit. Once the power and signal is restored the unit
will resume to capture program data when in the standby mode.
-
TV Guide On Screen System Operating Modes and Features
• Once the initial setup for the TV Guide On Screen is complete and the necessary
data is downloaded properly, the channel guide features will be ready for use.
The following section will provide a general description of the modes and
features available.
- Using the On Screen TV Guide system
- Navigating the On Screen TV Guide system
8
To Next Page
Loading...
