Panasonic DMR-EA18K

42
RQT9048
“Accessing the Setup Menu”
You will have to perform the following step 1 for all
other operations on pages 42-49.
With the unit stopped
Notes
Changed settings remain intact even when switching the unit to standby.
Tips
To return to the previous screen
Press [RETURN]. Even if you have changed an option, the change is
not activated until you press [OK].
To exit the screen
Press [SETUP].
IR Settings
Allow the set top box connected to this unit to be
recognized by this unit.
If the set top box setup is changed, carry out the “Test”
(➔ right) to check whether or not the Set Top Box
Control operates correctly.
Perform step 1 of “Accessing the Setup Menu”
(➔ above).
e
,
r
to select “Setup”, then
q
e
,
r
to select “IR Settings”, then
IR Settings
Select whether or not the set top box connected to this
unit is controlled by this unit.
After selecting “IR Settings” ( ➔ above, step 3) .
e
,
r
to select “IR Settings” , then
e
,
r
to select “On” or “Off”, then
w
,
q
to select “Yes” or “No”, then
STB (Set Top Box) Type
Select the service being used.
After selecting “IR Settings” ( ➔ above, step 3) .
e
,
r
to select “STB (Set Top Box)
Type”, then
e
,
r
to select “Cable Box / DVR”,
“Satellite Box / DVR”, “Converter Box”
or “IPTV / Other STBs”, then
Brand Name
Select the set top box brand.
After selecting “IR Settings” ( ➔ left, step 3) .
e
,
r
to select “Brand Name” , then
e
,
r
,
w
,
q
to select the set top box
brand, then
You can also use [
u
] or [
i
] to view other
pages.
–
Maximum Channel digits
Select the maximum number of channel digits to be
entered in your set top box.
After selecting “IR Settings” ( ➔ left, step 3) .
e
,
r
to select “Max.CH digits”, then
e
,
r
to select “Max. 2 Digit Channel
(CH xx)”, “Max. 3 Digit Channel
(CH xxx)” or “Max. 4 Digit Channel
(CH xxxx)”, then
This must not be selected when “Converter Box” is
selected for “STB (Set Top Box) Type” (➔ left).
OK Key Operation
Select whether or not the selected channel is confirmed
by pressing [OK] in accordance with your Set top box.
After selecting “IR Settings” ( ➔ left, step 3) .
e
,
r
to select “OK Key Operation”,
then
e
,
r
to select “On” or “Off”, then
Test
After selecting “IR Settings” ( ➔ left, step 3) .
e
,
r
to select “Test”, then
Confirmation screen appears.
Perform steps 8 and 9 on page 11.
–
–
•
Setup Menus