Recording
VQT4C70
27
Recording TV programmes
To set the recording time
1 Select “Recording Time” or “Continuous
recording” in step 3 (> left).
Recording Time:
You can set the length of recording time from
30 minutes to 4 hours.
• You can select the recording time with
[2, 1].
Continuous recording:
The recording is continued until you press
[STOP ∫].
2 Press [OK].
• One recording will terminate when simultaneous recording
is being done and timer recording starts.
• Teletext will not be recorded.
• Following operations cannot be performed while recording.
- playback of 3D BD-Video in 3D
- playback of DivX and MKV file
- playback of photo
- playback of USB memory
- copying of photo to the HDD
- copying of AVCHD video to the HDD
• When “Automatic Standby after OTR” is set to “On” (> 79),
this unit is turned to standby mode if this unit is not
operated for approximately 5 minutes after completing
“Automatic Stop” or “Recording Time”.
The titles can only be recorded to built-in
HDD and cannot be copied from built-in HDD
to the media other than USB HDD.
• This operation will only record to built-in HDD.
• This unit can record two programmes being
broadcasted at the same time.
1 Select the channel to record.
2 Press [REC ¥].
Recording starts.
• “REC1” or “REC2” will light on the unit’s
display.
3 Select “Automatic Stop”, then press
[OK].
• One touch recording (OTR)
Recording stops automatically when the
programme ends.
• You can also select “Recording Time” or
“Continuous recording”. (> right)
Automatic Stop at 8:45 AM
REC1/OTR
Recording Time
Continuous recording
30 min
8:00 AM - 8:45 AM
DMRPWT520GL_eng.book 27 ページ 2012年2月9日 木曜日 午後6時15分