65
Notes when attaching the tray:
Pull the Slide Cam to the left side and insert the tray
when attaching.
9.11.3. Pulley Gear, Belt and Mid Gear
1. Perform the step"9.12.2.Tray".
2. Push the post to the direction of arrow by using the
slotted screwdriver.
3. Remove the Pulley Gear, Belt and Mid Gear.
9.11.4. Slide Cam
1. Perform the step"9.12.3.Pulley Gear,Belt and Mid Gear".
2. Remove the sheet.
3. Open the connector lock, and disconnect the 4 FFCs.
4. Remove the Screw (A), Heat Sink and Drive P.C.B..
Caution:
Though the Drive P.C.B. is not supplied as replace-
ment parts,it must be removed for after disassem-
bling.
5. Remove the 2 Dampers.
6. Open the connector lock, and disconnect the OPU FFC.
7. Pull the Slide Cam to the right side.
To Next Page
Loading...
