66
8. Remove the Traverse Base Ass'y with spreading the 2
Hooks to the direction of arrows.
9. Remove the Slide Cam.
9.11.5. Drive Gear and Loading Motor
1. Perform the step"9.12.4.Slide Cam".
2. Remove the Drive Gear.
3. Remove the 2 soldering points.
4. Spead the 2 hooks to remove the Loading Motor.
Notes when assembling:
a. Align the location hole of the loading motor with the
base dowel pin.
b. The fixing style for the wire rod of the loading motor is
shown in the figure.
c. The stationary jaw of FFC is shown in the figure.
To Next Page
Loading...
