Panasonic DP-180 - Page 73

73
UF-9000
JUN 2004
Ver. 2.0
DP-180/190
4.1.8. F9 Mode: Unit Maintenance
Set the machine to Service Mode and press "9" key on the Keypad.
↓
Press the "START" key.
↓
Enter the desired code number or press “V”, ”/\” arrow keys.
↓
Press the "SET" key.
↓
Enter the desired function code number and press “SET” key.
↓
When the “CLEAR” key is pressed, the selected code input will not be accepted.
↓
Press “STOP” key, then press “FUNCTION” and “CLEAR” keys simultaneously to exit the service mode.
↓
Reboot the machine after setting the parameter(s) to activate the setting(s).
F9 Mode
Service
Mode
Item Remarks
F9 Unit
Maintenance
00 Fax Function Parameter
01 Service Alert Tel # Displays the contact number when a
machine malfunction occurs.
02 Firmware
Version
00 SC Displays the firmware version for SC.
01 SC Boot Displays the firmware version for SC
Boot.
02 PNL Displays the firmware version for PNL.
03 SPC (Scanner) Displays the firmware version for SPC.
04 Printer Displays the firmware version.
05 FAX Modem Displays the firmware version for FAX
Option 1.
06 Not Used
07 SC2 Displays the firmware version for Slot 1.
03 Print
Device Info.
00 F5/F6 Parameters Prints the memory contents of the F5
and F6 modes.
01 Machine Information Prints the machine setup information list.
02 Counter Information Prints the Counter information list.
03 System Address
Info.
Prints the system memory setting.
04 RAM Address
Information
Prints the RAM data dump list.
04 RAM Edit
Mode
1 Relative Address Setting of Relative address.
2 Absolute Address Setting of Real address.
05 Serial Number Registration of Serial Number for
Maintenance.
Clears by Shipment Set.