Panasonic DP-8016P

56
Function
23 DNS SERVER ADDR.
∗
2
Selects whether to enable the DNS Server, and 2:VALID
sets its settings for Internet Fax/Email Function.
1:INVALID
2:VALID
<Sub-Function>
1:HOST NAME / 2:DOMAIN NAME /
3:PRI. DNS SERVER (IP ADDRESS1) /
4:SEC. DNS SERVER (IP ADDRESS2)
24 MAC ADDRESS Indicates the MAC address.
25 HARD DISK FORMAT
∗
4
Formats the hard disk.
PRESS SET TO START
26 HARD DISK ERR CHK
∗
4
Selects the provision for the hard disk error check.
PRESS SET TO START
27 ABBR GROUP ID Inputs the Group ID for the address book. 0
0-99
28 COMMUNITY NAME(1)
∗
5
Selects whether to change the Community public
Name(1) SNMP.
Enable read only
29 COMMUNITY NAME(2)
∗
5
Selects whether to change the Community public
Name(2) SNMP.
Enable read/write
30 DEVICE NAME
∗
5
Inputs the device name when required.
(For Status Monitor/EtherTalk Machine Name)
31 DEVICE LOCATION
∗
5
Inputs the device location when required.
(For Status Monitor)
33 USER AUTH
∗
6
Set the User Authentication Mode.
COPY
1:INVALID / 2:VALID INVALID
FAX
1:INVALID / 2:VALID INVALID
PRINTER
1:INVALID / 2:VALID INVALID
SCANNER
1:INVALID / 2:VALID INVALID
34 AUTH DOMAIN Inputs the Authentication Domain Name
Domain Name: Up to 15 characters.
DNS Domain Name: Up to 60 characters.
No.
Modes Function
Initial
Setting
■ General Settings (For Key Operator) (Continued)
NOTE ∗4Available only when the optional Hard Disk Drive Unit is installed.
∗5 When Parameters No. 28 to 31 are set, cycle the power by turning the Power Switch on the Right Side of the
machine OFF and ON.
∗6 About the User Authentication, See Operating Instructions "For User Authentication".