I
i
2"3"4"5 .ETun"
ACTION
0 1D_sc_nguag_
O 2 Ratings Levelsd'
I 3MenuLanguage English
4On-ScreenMessages
_5 FL Display Bright
6TV Aspect 4:3
7DigitalAudioOutout
8 SpeakerSetting 2-channel
9OtherSettings
PressRETURNtoexil
I[ 1 Multi-channel
mJ! PressRETURNto exit
o I_
Press RETURN to exit
Home theater
Here you can change the settings for the built-in decoder.
These changes will have no effect if you connect the unit to other
equipment through the digital audio output terminal (make the neces-
sary changes on the other equipment).
I Common procedures
1 Press [ACTION] in the stop mode.
The initial settings screen is displayed.
2
3
4
Press the cursor buttons [&, _'] to se-
lect "8 Speaker Setting" and press
[ENTER].
Press the cursor buttons [&, V] to se-
lect the item and press [ENTER].
1 Multi-channel
If you have connected 3 or more speakers. (Proceed to
step 4)
2 2-channel (Factory preset)
If you have connected 2 speakers or an amplifier with
Dolby Pro Logic decoder. (You will return to the menu
shown in step 1. Settings are not necessary,)
Change settings to suit your speakers
and the listening position (- page39).
• Setting the size and presence of your speakers
Choose "Yes" for speakers you have connected. Sound will
not be output if you choose =No".
• Delay time
Allows you to make up for differences in distance if you
cannot place your speakers in the optimum position,
oChannel balance
Allows you to adjust the output level of the speakers to make
up for differences in volume caused by different types of
speaker or distance,
5 Press the cursor buttons [A, V, ,<,
I_] to select "Exit" and press
[ENTER].
The screen inustrated in step 2 is displayed.
To cancel during setup operation
Press [RETURN]. (The previous screen isdisplayed.)
To exit the initial settings screen
Press ]ACTION] or [RETURN].
5
To Next Page
Loading...
