Panasonic DVD-RV65

Connection to a television
• Ensure that this unit and other equipment to be connected are switched to the standby mode or off and disconnect the AC power supply cord
before commencing connection.
oread through the instructions before connecting other equipment.
• Ensure that you observe the color coding when connecting audio and video cables.
• See page 32 for info}mation about how to upgrade your system with other audio/visual equipment.
i • Peripheral equipment and optional cables sold separately unless otherwise indicated.oTV volume may be lower when playing DVDs than during television broadcasts. Turn the volume up while playing DVDs and reduce it to the
previous level before switching the source back to television to avoid sudden changes in volume.
'_ •When you have finished connection, select the appropriate screen type at the initial setting"6 TV Aspect" according to your television (4:3/16:9)
1 No needed if connect the unit to a conventional television
(-
page
O). changes
are
you (4:3).
Conserving power
• The unit consumes approx, 2.0 W even when it is turned off with [POWER _/I]. To save power when the unit is not to be used for a long time,
•_ unplug it from the household AC outlet.
q)
Connect Your Unlt Directly To Your Tele- Do not place the
vision, unit on ampllflers or
If the unit Is connected to the television through a video cassette other equipment
recorder, the picture may not be played correchy due to the whi_h may become
copy guard. So we strongly recommend you do not connect the
unit to your video cassette recorder when setUng up your home hot.
entertainment system. The heat can damage the unit.
eConneot to the tete_ision section if you connect the unit to a
combined televi_K)n-video player,
Audioh/ideo cable (included) --
(See the note at the bottom of this page.) --
RL_AUDtO VIDEO S VIDEO
IN IN IN
: ON
:
S video output terminal
Television
......
TO household AC outlet
(AC 120 V, 60 Hz)
[]
AC power supply cord --
(included)
--S video cable
L J
Back of the unit
The S (separate) video output terminal achieves a clearer picture
than the video output terminal by separating the chrominance (C)
and luminance (Y) signals before transmitting them to the television.
(Actual results depend on the television.)
elf your television is monaural, use a stereo-monaural audio cable instead of the supplied audio/video cable. The video part of the cable (yellow)
can stillbe used if required. Audio cable
_(_.:_1 _ _ To unit's audio output terminal (white, "L")
To TV audio input terminal 4i _ To unit's audio output terminal (red, "R")