Panasonic DVD-S38

14
Connections
Connecting digital AV receiver
AV OUT
DI GI TA L A U DI O O UT
(PCM/BITSTREAM)
VIDEO OUT
COMPONENT VI DEO OUT AUDI O OUT
VIDEO OUT
AUDIO OUT
COMPONENT VIDEO OUT
DIGITALAUDIO O UT
(PCM/BITSTREAM)
DVD-S58 DVD-S38
COAXIAL INCOAXIAL IN
Coaxial cable
AV Receiver
Coaxial cable
Set the DVD Player’s Digital Audio Out to PCM or Bitstream depending on the
capabilities of your Receiver (see DVD Menu options > {Audio Out}). (

page 26)
Tip:
If the audio format of the Digital Output does not match the capabilities of your
receiver, the receiver will produce a strong, distorted sound or no sound at all.
Connecting the power cord
After everything is connected properly, plug in the AC power cord to the power
outlet.
Never make or change any connections with the power switched on.
–
The unit should be installed near an
accessible AC power outlet, with the power
cord connected directly to it.
To completely disconnect power from the
unit, unplug the power cord from the AC
power outlet.
This unit consumes a small amount of
AC power even when turned off. In the
interest of power conservation, if you will
not be using this unit for an extended
period of time, it can be disconnected.
–
14
DVD-S58S38PP-En.indd14DVD-S58S38PP-En.indd14 2010/01/0816:27:182010/01/0816:27:18