OPERATINGINSTRUCTIONS
MCUK000601C8 Section 3 Issue 1
Service Manual – 9 – Revision 0
3.9. Public Man Machine Interface (MMI)
3.9.1 General
It is possible to operate all GSM telephones in the same way using the Public MMI. The following operations will work with all
GSM telephones. However, this information is restricted to those operations supported by GD52, GD92 and GD92C
telephones.
The * and # in the following procedures should be replaced by and respectively. Also <SND> and <END> should be
replaced with and keys.
3.9.2 Reading the Phonebook Memory Location
# <MEMORY LOCATION>
Leading zeros can be left out of the location number, e.g. 007 can be 7.
3.9.3 Presentation of IMEI
* # 0 6 #
3.9.4 Security
Change PIN * * 0 4 * <OLD PIN> * <NEW PIN> * <NEW PIN> #
Change PIN2 * * 0 4 2 * <OLD PIN2> * <NEW PIN2> * <NEW PIN2> #
Unblock PIN * * 0 5 * <PIN UNBLOCKING KEY> * <NEW PIN> * <NEW PIN> #
Unblock PIN2 * * 0 5 * <PIN2 UNBLOCKING KEY> * <NEW PIN2> * <NEW PIN2> #
3.9.5 Call Hold
Place a Call on Hold 2 <SND>
Recall a Held Call 2 <SND>
Make a Second Call <TELEPHONE NUMBER><SND>
Swap between two Held Calls 2 <SND>
End Held Call 0 <SND>
End Active Call 1 <SND>
Reject Incoming Call 0 <SND>
3.9.6 Call Waiting
Enable Call Waiting * 4 3 * <SND>
Disable Call Waiting # 4 3 * <SND>
Call Waiting Status * # 4 3 * # <SND>
3.9.7 Calling Line Identification
Enable * <SERVICE CODE> * # <SND>
Disable # <SERVICE CODE> * # <SND>
Temporary Suppress Identification * 4 3 * <SND>
Temporary Display Identification 4 3 * <SND>
Feature Service Code
Calling Line Identification Presentation (CLIP) 30
Calling Line Identification Restriction (CLIR) 31
Connected Line Presentation (CLOP) 76
Connected Line Restriction (CLOR) 77
To Next Page
Loading...
