Panasonic EB-GD55 - Spurious Emissions at Antenna Connector; Residual Peak Power; Rx Characteristics; Sensitivity

– 5–2 –
5.1.5. Spurious Emissions at Antenna Connector
5.1.6. Residual Peak Power
Limits (dBm)
Frequency
Range
Frequency
Offset
Filter
Bandwidth
Approx.
Video B/W
E-GSM 900 GSM 1800
Equal to or less than 70 dBc (BW = 300 kHz)
5.2.1. Sensitivity
E-GSM 900 Full Rate Speech
The reference sensitivity performance in terms of frame erasure, bit error, or residual bit error rates (whichever is appropriate)
is specified in the following table, according to the propagation conditions.
Channels
Propogation
Conditions TUhigh
Propogation Conditions
RA
Propogation Conditions
HT
Static Conditions
Test
Limit
error
rate %
Minimum
No. of
samples
Test Limit
error rate
%
Minimum
No. of
samples
Test Limit
error rate
%
Minimum
No. of
samples
Test
Limit
error
rate %
Minimum
No. of
samples
TCH/FS FER
Class lb (RBER)
Class ll (RBER)
6.742∗_
0.42/_
8.33
8900
1,000,000
120,000
7.5 24000 9.333 60000
0.122∗_
0.41/_
2.439
164000
20,000,000
8200
The reference sensitivity level is < –102 dBm.
5.2. Rx Characteristics
Note: 1 < α < 1.6.The value of α can be different for each channel condition but must remain the same for
FER and Class 1b RBER measurements for the same channel condition.
100 kHz to 50 MHz – 10 kHz 30 kHz –36 –36
50 to 500 MHz – 100 kHz 300 kHz –36 –36
500 MHz to 1 GHz 0 to 1 MHz 100 kHz 300 kHz –36 –36
1 GHz to 12.75 GHz 0 to 10 MHz 100 kHz 300 kHz –30 –30 (1.0 – 1.710 GHz)
Excl. relevant TX band: > 10 MHz 300 kHz 1 MHz –30 –36 (1.710 – 1.785 GHz)
E-GSM: 880 to 915 MHz; > 30 MHz 3 MHz 3 MHz –30 –30 (1.785 – 12.75 GHz)
DCS: 1710 to 1785 MHz (offset from edge of
– and the RX band relevant TX band)
925 – 960 MHz
1805 – 1880 MHz
Relevant TX band: 1.8 to 6.0 MHz 30 kHz 100 kHz –36 –36
E-GSM: 880 to 915 MHz; > 6.0 MHz 100 kHz 300 kHz –36 –36
DCS: 1710 to 1785 MHz