Call Charges
To maintain control over the cost of calls that are made, the phone can be set to
restrict use to a finite number of units overall.
Setting the Unit Price
Firstly, a price per unit must be entered. This is the cost that the Service Provider
charges for one unit of call time.
1
From Idle mode press
B 662
to enter the Price/Unit menu
2
Press
B
to edit the values
At this point you will be asked to enter your PIN2.
3
Enter a currency unit (up to three characters) and press
B
4
Enter a price and press
B
Setting the Maximum Unit Level
1
From Idle mode press
B 663
to enter the Max Cost menu
2
Press
B
to edit the values
At this point you will be asked to enter your PIN2.
3
Enter a value (number of units) which is to be the maximum permitted, and the
corresponding cost will be displayed
4
Press
B
to accept
Note: The duration of one unit may vary during the day, peak and off-peak times.
Therefore, the call charge can be calculated accordingly. However, call charge
information may not give an accurate reflection of the tariffs charged by your Service
Provider.
Setting a Warning Level
A warning can be set as an indication that the maximum cost is about to be reached.
1
From Idle mode press
B 664
to enter the Warning at menu
2
Press
B
to edit the value
3
Enter a value (in units) at which time you would like the warning to sound and
press
B
Call Identification
In the Call Service menu, the Caller’s ID and Withhold ID functions allow you to
check the status of whether a Caller’s Identification is sent or can be received.
Note: When checking the status the phone must be registered with a network.
30
Call Information
To Next Page
Loading...
