Panasonic Eco Solutions Nordic AB
MEW01624 Rev: - EBL128 version 2.0.x, Daily user's manual
24
7.3 Sensor values (U3)
NOTE! The Performance factor and the Min. and Max values are
updated at midnight, i.e. the values are from the previous day.
If the week average sensor value ("Weekly") is 00.0%/m, check again
approx. 2 minutes later.
If the list is empty, "- - - List is empty - - -" will be shown.
Log in with a User name and Password for typ Building officer (or
Service personnel), see page 5.
H1 Perform monthly test
Scroll (or press "4") to menu H4.
H4 Present system status
Press "A" to sub menu U1.
U1 Disablement
Scroll (or press "3") to menu U3.
U3 Sensor values
Press "A". Use the keypad to specify the "Start sensor:". The default
zone-address 00-00 can be used.
Press "A". This is a list in which you can scroll. Depending on if it is
a heat, smoke or multi detector, the information
is different. For a
multi detector use "→" for more information. After the last detector /
sensor, "No more sensors found in the system" will be shown.
Press "Return" (P9) two times to menu U3.
Scroll to another menu or press "Return" to menu H4. Scroll to
another menu or leave the menu system by pressing "Return".
To Next Page
Loading...
