Panasonic EBL128

Panasonic Eco Solutions Nordic AB
MEW01624 Rev: - EBL128 version 2.0.x, Daily user's manual
1
Table of contents
1 Introduction________________________________ 3
2 Front______________________________________ 4
3 Log on to the Control Unit (c.i.e.) ______________ 5
4 Perform monthly test (H1) ___________________ 9
5 Disable or re-enable (H2) ___________________ 10
5.1 Disable zone (B1) _________________________________ 10
5.2 Disable zone-address (B2) __________________________ 11
5.3 Disable output (B3) _______________________________ 12
5.4 Disable all control, ventilation, exting or interlocking outputs
(B4) 13
5.5 Re-enable zone (B5) _______________________________ 14
5.6 Re-enable zone-address (B6) ________________________ 15
5.7 Re-enable output (B7) _____________________________ 16
5.8 Re-enable all control, ventilation, exting or interlocking
outputs (B8) ___________________________________________ 17
5.9 Disable / re-enable alarm devices (B9) ________________ 18
5.10 Disable / re-enable outputs for routing equipment (B10) ___ 19
5.11 Disable / re-enable alert annunciation function (B11) _____ 20
6 Set calendar and clock (H3) _________________ 21
7 Present system status (H4) __________________ 22
7.1 Disablement (U1) _________________________________ 22
7.2 Disablement by time channel (U2)____________________ 23
7.3 Sensor values (U3) ________________________________ 24
7.4 Sensors activating SERVICE signal (U4) ______________ 25
7.5 Technical warning (U5) ____________________________ 26
7.6 Event log (U6) ___________________________________ 27
7.7 Version and alarm counter (U7) ______________________ 28
8 FAULT Acknowledge (H6) __________________ 29
9 Perform ZONE TEST (H7) _________________ 30
10 Interlocking outputs and inputs (H9) _________ 31
10.1 Activated interlocking outputs / inputs (C1) ____________ 31
10.2 Activate interlocking output (C2) ____________________ 32
10.3 Reset interlocking output (C3) _______________________ 33
10.4 Disable interlocking output (C4) _____________________ 34
10.5 Re-enable interlocking output (C5) ___________________ 35
11 Change password (H10) ____________________ 36
12 Revision history ____________________________ 37