Display Area
(P.5)
10
Washing
Press .
Close the lid.
Press
repeatedly to select
a cycle. (P.12)
Open the lid, and add detergent
to the liquid detergent inlet or
powdered detergent inlet in the
amount appropriate for the
water level.
If using softener, add it to the softener inlet. ●
Press .
The washing machine will measure the ●
laundry load by churning the laundry without
any water, and display the water level.
5
2
1
4
3
The cycle is complete when the washing machine beeps. (P.15)
Turn off the water taps and take out the clothes.
Note
You cannot change the cycle once you ●
press the [Start] button. To change the
cycle, turn off and on the washing
machine, and set cycle settings again.
Select the water temperature (P.11) ►
Select the wash/rinse/spin settings (P.11) ►
Set the finish time (P.11, Timer Delay) ►
Select the water level (P.11) ►
About Detergent (P.20) ►
Before you begin
Load clothes in the tub, close the lid, and turn on the water taps. ●
1$)6B*BHQJLQGG
To Next Page
Loading...
